Image Annotation

In manual mode (see Manual Mode), oriented bounding boxes can be added or modified in the Image tab (T0).

Adding a bounding box: Add a new bounding box in three steps:

  1. Double-click where you want the bottom edge of the bounding box to be. This edge is displayed in purple.

  2. Click the upper edge of the object to set the height of the bounding box.

  3. Click a point on either side of the object to set the width of the bounding box.

Selecting a bounding box: Left-click an existing box to select it. A selected box is highlighted in a slightly different color and displays four yellow circular corner handles.

Changing the label: While a bounding box is selected, you can change its label by selecting another label from the label panel or by entering a new label.

Modifying a bounding box: A selected box can be modified in several ways:

  • Drag inside the box to move it.

  • Drag an edge to resize the box in that direction.

  • Drag a corner to rotate the box around its center.

Deleting a bounding box: Right-click a selected box to delete it.

Most functions in the admin control group are only available while manual mode is active. This prevents conflicts with PLC-controlled operation.